Wire Frame Settings Window
The dialog window shown on this page can be found under
SoftMold’s Setting Menu.
This dialog controls how the mold base function creates wire frame entities.
SoftMold will create centerlines and points on the holes in the mold base.
This dialog allows you to control how these wire frame features are created.
These setting are stored in SoftMold’s database and used each time you create a mold base.
You can also control the length of the centerline. The length of the centerline is based on
the diameter of the hole multiplied by the line length scale factor.
A scale factor of 100 will create a line equal to the hole diameter. A higher value will
create a longer line.
